Open Access

Mapping multiple QTL using linkage disequilibrium and linkage analysis information and multitrait data

Genetics Selection Evolution200436:261

DOI: 10.1186/1297-9686-36-3-261

Received: 17 February 2003

Accepted: 10 November 2003

Published: 15 May 2004

Abstract

A multi-locus QTL mapping method is presented, which combines linkage and linkage disequilibrium (LD) information and uses multitrait data. The method assumed a putative QTL at the midpoint of each marker bracket. Whether the putative QTL had an effect or not was sampled using Markov chain Monte Carlo (MCMC) methods. The method was tested in dairy cattle data on chromosome 14 where the DGAT1 gene was known to be segregating. The DGAT1 gene was mapped to a region of 0.04 cM, and the effects of the gene were accurately estimated. The fitting of multiple QTL gave a much sharper indication of the QTL position than a single QTL model using multitrait data, probably because the multi-locus QTL mapping reduced the carry over effect of the large DGAT1 gene to adjacent putative QTL positions. This suggests that the method could detect secondary QTL that would, in single point analyses, remain hidden under the broad peak of the dominant QTL. However, no indications for a second QTL affecting dairy traits were found on chromosome 14.

Keywords

QTL mapping linkage analysis linkage disequilibrium mapping multitrait analysis multi-locus mapping

(To access the full article, please see PDF)

Authors’ Affiliations

(1)
Centre for Integrative Genetics (Cigene), Institute of Animal Science, Agricultural University of Norway
(2)
Institute of Land and Food Resources, University of Melbourne, and Victorian Institute of Animal Science

Copyright

© INRA, EDP Sciences 2004

Advertisement